[wpilib] Add Koors40 motor controller (#7469)

wpilibc/src/generated/main/native/cpp/motorcontrol/Koors40.cpp

@@ -0,0 +1,20 @@
+// Copyright (c) FIRST and other WPILib contributors.
+// Open Source Software; you can modify and/or share it under the terms of
+// the WPILib BSD license file in the root directory of this project.
+
+// THIS FILE WAS AUTO-GENERATED BY ./wpilibc/generate_pwm_motor_controllers.py. DO NOT MODIFY
+
+#include "frc/motorcontrol/Koors40.h"
+
+#include <hal/FRCUsageReporting.h>
+
+using namespace frc;
+
+Koors40::Koors40(int channel) : PWMMotorController("Koors40", channel) {
+  m_pwm.SetBounds(2.004_ms, 1.52_ms, 1.5_ms, 1.48_ms, 0.997_ms);
+  m_pwm.SetPeriodMultiplier(PWM::kPeriodMultiplier_4X);
+  m_pwm.SetSpeed(0.0);
+  m_pwm.SetZeroLatch();
+
+  HAL_Report(HALUsageReporting::kResourceType_Koors40, GetChannel() + 1);
+}

wpilibc/src/generated/main/native/include/frc/motorcontrol/Koors40.h

@@ -0,0 +1,43 @@
+// Copyright (c) FIRST and other WPILib contributors.
+// Open Source Software; you can modify and/or share it under the terms of
+// the WPILib BSD license file in the root directory of this project.
+
+// THIS FILE WAS AUTO-GENERATED BY ./wpilibc/generate_pwm_motor_controllers.py. DO NOT MODIFY
+
+#pragma once
+
+#include "frc/motorcontrol/PWMMotorController.h"
+
+namespace frc {
+
+/**
+ * AndyMark Koors40 Motor Controller with PWM control.
+ *
+ * Note that the Koors40 uses the following bounds for PWM values. These
+ * values should work reasonably well for most controllers, but if users
+ * experience issues such as asymmetric behavior around the deadband or
+ * inability to saturate the controller in either direction, calibration is
+ * recommended. The calibration procedure can be found in the Koors40 User
+ * Manual available from AndyMark.
+ *
+ * \li 2.004ms = full "forward"
+ * \li 1.520ms = the "high end" of the deadband range
+ * \li 1.500ms = center of the deadband range (off)
+ * \li 1.480ms = the "low end" of the deadband range
+ * \li 0.997ms = full "reverse"
+ */
+class Koors40 : public PWMMotorController {
+ public:
+  /**
+   * Constructor for a Koors40 connected via PWM.
+   *
+   * @param channel The PWM channel that the Koors40 is attached to. 0-9 are
+   *                on-board, 10-19 are on the MXP port
+   */
+  explicit Koors40(int channel);
+
+  Koors40(Koors40&&) = default;
+  Koors40& operator=(Koors40&&) = default;
+};
+
+}  // namespace frc